v0.31:Murky pool

xTATTEREDx  · +FINE+  · *SUPERIOR*  · ≡EXCEPTIONAL≡  · ☼MASTERWORK☼

v50.12 · v0.47 · v0.34 · v0.31.25 · v0.28 · v0.23 This article is about an older version of DF. More Info · V

Murky pools are small pools of Template:L on the surface of the map. They can be filled with freshwater, saltwater or brackish water.

Murky pools act as a finite water source and a biome.

As a water source

A pool can be used as a water source and Template:L with the Template:L labour enabled will attempt to fish in them.

Murky pools can evaporate completely in Template:L in sufficiently hot Template:Ls, or can be Template:L, but in either case can be refilled by Template:Lwater or melting Template:L or Template:L.

Drinking from a murky pool will give dwarves an unhappy Template:L. Dwarves will not normally drink from murky pools if they can at all help it; preferring alcohol, well water, or running water from a brook/stream/river over water from a murky pool.

Using water from a murky pool to wash injuries results in a higher chance of the wound becoming Template:L

Sometimes the only Template:L visible on the map is in murky pools. In hot and scorching climates, its typically a good idea to quickly create a Template:L to collect the water from murky pools before it all evaporates.

As a biome

The Template:L pool means the area in the pool (under water) and close by the pool. This kind of biome won't be shown on the Template:L , but most biomes have some.

There are six types of pools, divided in climate and the kind of water. They are listed in the following table:

	Brackish water	Freshwater	Saltwater
Temperate	Temperate brackish pool	Temperate freshwater pool	Temperate saltwater pool
Tropical	Tropical brackish pool	Tropical freshwater pool	Tropical saltwater pool

Removing

In order to remove a murky pool, you must first remove the water. You can do this with a Template:L, or you can let pools evaporate in hot/scorching climates, or you can just dig into your pools from the side and let the water drain away and evaporate.

The bottom of a murky pool will keep its "murky pool" status, presumably to let the game know that water should collect there during rain storms. You can't build certain structures, including farm plots, on dry "murky pool" tiles.

To de-murk those tiles, simply build a paved road on top of them, and then remove it. The floor covered by the road will become standard soil once the road is removed. Be aware that once you do this the tiles won't gather rainwater anymore.

In version^{v0.28.181.40d}, a drained Murky Pool tile would block Depot Access. It is unknown if this has changed in the current version.

Fauna

Only very few creatures are found in murky pools. There are:

• Template:Ls
• Template:Ls
• Template:Ls
• additionally Template:L can be found in tropical pools
• Template:L and Template:L can be found near in pools in Template:L areas
• and Template:Ls can be observed in Template:L biomes

Adventure Mode

Conducting combat around murky pools is dangerous, as you may dodge or be thrown into them and drown. Dried Murky Pools are even more dangerous, as no amount of Template:L skill can save you.

Thawing and drowning

In fortress mode, frozen murky pools will, when they thaw, do so instantly. Any dwarf standing on the ice will plunge into the water with a risk of drowning if they can not find a nearby ramp quick enough. (unless they have Adequate or better Template:L skill, the fall will Template:L them.). To reduce the chance of this happening, you can use Template:L designations: mark the ice as restricted, and put a high traffic ring around the perimeter of the pool. Or, if you don't need to Template:L from it, you can Template:L a Template:L around it or a Template:L over it.