40d:Windmill

Windmill

b-M-m
║   O   ║ X X X X X X X X X
Construction
Materials	Jobs
4 Wood	Architecture Carpentry
Power
Generates 40, 20, or 0 power, depending on wind level

A windmill is a machine component that provides power via wind on the surface of a fortress map. The power produced by each windmill depends on your fortress location.

When it works

A windmill generates power under the following conditions:

1. Its center tile is outside.
2. The map has wind.
   • Some maps have strong wind (40 power per windmill), some have weak wind (20 power), and some have no wind at all.
3. It is not connected to frozen machinery, such as a screw pump or water wheel in ice.

When all of these conditions are met, the windmill will produce power at its center square and transmit it downwards.

Construction

To place a windmill, it must either be supported by machinery from below or on a stable foundation (floor). In either case, the build site must be reachable. Either from one of the tiles the windmill is being built on or from adjacent surrounding tiles.

Variants

Standard windmill

1. Build the windmill.
2. Excavate a path under it to the center of its base, 1 z-level down.
3. Add a vertical axle, gear assembly or machine there, which will have power. A floor between the windmill and this is fine.

Windmill tower

The "windmill tower" option is useful if you can't dig below your windmill (if, for example, there is a room or underground river there).

1. Build a 3×3 platform (or 8-tile ring) out of floors one level above the ground floor.
2. Build the windmill on top of the platform.
3. Directly beneath the windmill, on the ground floor, build a gear assembly.
4. Connect this assembly to horizontal axles, and power your machines.
5. If desired, remove excess floors/stairs.

Sunken windmill

You can build windmills underground if the central square in the windmill is "outside" (channel the roof away above it).

Windmill farm

Several windmills can be linked together via gear assemblies and axles. The first windmill needs a gear assembly beneath it. After that, each windmill will require one gear assembly beneath it and two axles to connect to the next windmill. On high-wind maps, this gives 35 power for the first windmill, and 33 power for each extra windmill. On low-wind maps, this is reduced to 15 power for the first and 13 power for additional windmills.

Hanging windmill

1. Build building you want powered and up stairs with one tile between them.
2. Build down stairs above the up stairs.
3. Build windmill directly over building that needs or transfers power.
4. (optional) remove the stairs.

This option has one main weakness: It can't be used to power gear assemblies that are linked to levers/pressure plates, because as soon as the assembly turns off it stops supporting the windmill which falls down.

Using the power

Getting power out of a hanging windmill is straightforward. As long as the machinery it's hanging on is a vertical axle, gear assembly, or screw pump, it will be powered.

Windmills with stable foundations are harder. A vertical axle or gear assembly beneath the center tile should always be powered, but the actual behavior seems buggy or non-intuitive; if it doesn't work, try re-building the machinery below the windmill.

Construction Examples

See Machinery/Examples.