- v50 information can now be added to pages in the main namespace. v0.47 information can still be found in the DF2014 namespace. See here for more details on the new versioning policy.
- Use this page to report any issues related to the migration.
Difference between revisions of "40d:Power"
(→Power Requirements: Who the hell cofused screw pump with water wheel? What is "large machine bits"?) |
|||
| Line 5: | Line 5: | ||
*[[Gear assembly]]: (5) | *[[Gear assembly]]: (5) | ||
*Large machine bits: (10) | *Large machine bits: (10) | ||
| − | *[[ | + | *[[Screw pump]]: (10) |
==Power Generation== | ==Power Generation== | ||
Revision as of 16:21, 18 December 2007
Power is used to drive devices such as pumping water using a screw pump or milling certain types of food into flour at a millstone. Power is produced by windmills and water wheels.
Power Requirements
- Axle: (1) per tile
- Gear assembly: (5)
- Large machine bits: (10)
- Screw pump: (10)
Power Generation
- Water wheel: (100), flow required
- Windmill: variable, above ground only. Values of (20) and (40) have been reported.
Power Transfer
Power can be transfered between devices using gear assemblies and axles. Gear assemblies take up a single tile and connect power to any device within the six orthogonally adjacent tiles (north, south, east, west, above, below). Gear assemblies are best used for moving power through right-angles. For example, they can be built as bases for windmills to move power out sideways along an axle.
Because of the high power use of gears assemblies (5), axles are more appropriate and convinient to build when transferring power across horizontal or vertical distances. An axle uses (1) power for every tile of power transfer. A an axle 5 tiles long will use (5) power. Axles can be directly attached to widmills, waterwheels and screw pumps in order to provide power.
Devices that use power are also capable of transfering it. Adjacent screw pumps will transfer power betweem themselves. The only way to prevent this is to leave a tile gap between devices, or move them diagonally from each other.
Power Control
Connecting a power source such as a windmill directly to a screw pump will force the device to be in constant operation. To stop the screw pump either the power source or the pump must be dismantled.
A better alternative is to use a lever connected to a gear assembly. Levers can be used to move the gear assembly between a working state and deconstructed state. Note: any hanging devices being supported by the gear assembly will collapse to their base materials when it is disabledv0.27.169.33f. To prevent this from happening, hook up the lever to a second gear assembly attached to the supporting one.