- v50 information can now be added to pages in the main namespace. v0.47 information can still be found in the DF2014 namespace. See here for more details on the new versioning policy.
- Use this page to report any issues related to the migration.
v0.34 Talk:Mechanical logic
Cart-based power-to-signal converter (cross-section)
|
Where ▲ is E/W (N/S) track ramp
^ is a pressure plate,
r is a roller (highest speed)
. is E/W (N/S) track
Power feeds in beside the roller on the lower level. Rollers can not be powered from above.
A cart is fed into the system with a little push from the upper-level track. Ramps hold it in place over the roller. When powered, cart travels rapidly back and forth over pressure plate, maintaining 'on' state. This can then be used to power doors, bridges, etc.
--TerryDactyl 02:07, 21 May 2012 (UTC)
Miniaturized cart-based power-to-signal converter (overhead)
|
where P is power source
a are each gear assemblies
arrows represent rollers and direction of force
^ represents a pressure plate.
Be careful priming this machine. I'm not entirely sure, but I doubt it should be loaded in the active state.
Delay is ~10 or 11 ticks to trigger the plate. --TerryDactyl 04:16, 25 May 2012 (UTC)