v0.31:River

v50.14 · v0.47 · v0.34 · v0.31.25 · v0.28 · v0.23 This article is about an older version of DF. More Info · V

There are five different kinds of surface rivers in dwarf fortress. These are major rivers, rivers, minor rivers, streams and brooks. For most purposes all of these will be referred to as simply rivers and brooks since the only real difference between the first four types is their appearance in the regional map, their width, and possibly their rate of flow. Brooks being the smallest type of surface river do have the unique property that they can be crossed safely without needing to Template:L or even get ones feet wet.

Rivers

In fortress or adventure mode rivers can be seen as dark blue ≈ and ~ tiles stretching from one edge of the map to another. Rivers come in a variety of sizes from the major rivers spanning as wide as 40 tiles to tiny brooks which are only four tiles wide. River tiles will also be constantly blinking which indicates that the water has Template:L. Rivers are an effectively unlimited source of water flowing from the upstream side and leaving the map at the downstream.

To determine which direction downstream is you can carefully look at the ends of the river using k to look for tiles that have less than 7/7 water in them. This low point is the downstream side of your river. You may need to remove a small amount of water from the river before you can identify which end is the downstream side. Alternatively you can also turn on SHOW_FLOW_AMOUNTS in your init.txt file which will reveal the depth of water without needing to use k to look. This will however remove your ability to see Template:L. A dwarfier method would be to kill something, gets its blood in the river and observe the direction of its movement.

Rivers cannot be crossed without first building a bridge, drawbridge, or floor across them. Dwarves finding themselves unfortunate enough to be in a river are likely to be quickly swept downstream and drowned unless they are exceptionally good at Template:L.

Brooks

a Template:L is the smallest type of Template:L and is listed separately here because brooks have a unique property that allows Template:L and Template:L to travel across them without needing to Template:L. Walking across a brook will not even get your feet wet. A brook can easily be identified by the white and cyan ≈ and ~ tiles on the surface. Like a river these tiles will be constantly blinking indicating that they have Template:L These lighter colored tiles are a special kind of floor tile which acts much like a floor grate. Fluids, such as Template:L and water itself, will fall through it. And fisherdwarves can stand on the surface to fish without even needing to get their toes wet.

Template:L will not function if placed directly on a brook. In order to get a water wheel to work on a brook, you must dig a Template:L through the Template:L of the brook, which removes the special floor tile which makes the surface of a brook walkable. Once this is done a water wheel may be placed normally. In all other respects brooks function exactly like any other river.

Rivers in the regional map

On the regional map there are actually five different classifications of rivers identified by their appearance and the text displayed at the right side of the screen when you place your cursor over one of them. The five different classifications from largest to smallest are major rivers, rivers, minor rivers, streams and brooks. Brooks are not directly visible on the regional map but can be still see in the left most window and will also be indicated at the right if you select a tile containing a brook.

On the surface of the world you can find 5 different types of rivers.

Different sorts of rivers in action; note that the labeled Brook is actually a Stream

Rivers are found on the surface of world maps. They vary in width and flow rate, some being wider and than others. They often flow through deep canyons or just across the flat surface of a level. On levels with Template:L, Template:L may be found.

• Major rivers can be identified on the regional map by their double dark blue lines which easily identifies them from other types of rivers which only have single lines. Major rivers are the largest rivers, potentially exceeding 40 tiles in width. Usually they have minor river tributaries and can often feed large Template:L. The massive amount of flowing water found in a major river may have a negative effect on your fps.
• Rivers can be identified on the world map as dark blue and usually have tributaries of minor rivers. They can often be over 10 tiles wide.
• Minor rivers are medium blue and usually have tributaries of streams. They are usually between 7 and 10 tiles wide.
• Streams show as light blue on the region map and often converge with other streams, and have some tributaries of brooks. They tend to be 4-6 tiles wide.
• Brooks are not directly visible on the region map although they may be seen in the leftmost screen and also in the text at the right. They are the smallest flowing body of Template:L that can be found in the game, being only 4 tiles wide. Brooks are unique in the fact that they can be crossed safely without needing to Template:L or even get ones feet wet. Brooks are very common - almost every tile around a stream or larger river will have a brook running through it.

Underground Rivers

The existence of underground rivers as seen in previous versions has not yet been verified. If you have any information on how underground rivers may work in DF2010 please update this, or at least drop a note in the discussion area. Thank you. It would seem that underground rivers do indeed exists, I haven't done any further research on them though.

Other Important Facts

• Rivers contain an unlimited amount of water and cannot be drained like muddy pools. They can, however, be dammed if you can *temporarily* drain part of them to 1/7 or less for long enough to construct Template:L or install Template:L. Despite being an unlimited source of water, river source tiles will only refill up to the level of the river: it will not overflow if you dam it up. This demonstrates one way to drain and dam a river: [1]. Another way to dam a river is to direct a lava flow into it, producing obsidian in the squares where it encounters water.
• Once dammed, a dry riverbed will refill when it rains, similar to a Template:L.^[Verify]
• A dammed river will cease to produce additional water once all of its tiles reach 7/7, even if the dam is subsequently opened. Once the water level near the river's source drops below 7/7, though, the river will start producing water again.^[Verify]