|This article is about the current version of DF.|
Needs 5 power.
A gear assembly is a machine component that is used to transmit power from one adjacent machine component to another, such as water wheels, windmills, axles, screw pumps, millstones and other gear assemblies. Gear assemblies are required to change the direction of power flow, whether a horiztonal x- and y-axis change on the same z-level, or a change between vertical (z-axis) and horizontal (either x- or y-axis) to/from a differant z-level – that is, any change of 90°. A gear assembly is constructed from a single mechanism. A screw pump can be used to change the direction of power flow without using a mechanism (for instance when metal and stone are unavailable).
Gear assemblies require 5 units of power each.
Gear assemblies do not block unit movement and can be crossed by dwarves without danger. However, digging a channel to transfer the power (such as for an axle or a pump) below a gear assembly can result in a hole that cannot be crossed.
For a basic overview of how the different machine parts work and work together, see machinery.
Gears can be constructed from the mechanism to construct.uild menu under achine Components and ear. They require one
After the gear assembly has been constructed, it will automatically draw power from an adjacent power source. Further components can then be connected to the other available sides (East, West, North, South, Above, Below) of the gear assembly, and will automatically draw power from the power source via the assembly. Note that gear assemblies do not transfer power diagonally; they only work orthogonally (N–S, E–W, up–down).
In order to transfer power between z-levels with a gear assembly, you must first dig a channel, and then place the gear over the opening. Then place either another gear assembly, a vertical axle, or a machine (screw pump, etc.) on the z-level below in the same square, and power will be routed to it. They can also be built on stair tiles, however they will not transfer power through z-levels when placed like that.
Gears can be "disconnected" by being connected to a lever, and then pulling that lever. However, be warned that if a device is supported entirely by a gear, it may collapse when the gear is disconnected. The same is true of a horizontally connected hanging device. An example is a windmill built directly on top of a gear with no floor: in this case, disconnecting the gear via the lever will cause the windmill construction to collapse. In order to avoid this, create a second gear adjacent to the linked gear but not otherwise connected to the system; this gear will support the windmill if the linked gear is disconnected, but will not transfer power, since it only draws it from the now-disconnected gear.
Note that the above is only necessary if the machine component is entirely unsupported outside of the gear on which it rests. Components which have "Stable foundation" in theirview should not collapse if a gear beneath them is disconnected.
|"Gear assembly" in other Languages
|Workshops • Furnaces|
|Furniture||Animal trap • Armor stand • Bed • Box • Bucket|
Cabinet • Cage • Coffin • Display case • Pedestal
Restraint • Seat • Slab • Statue • Table • Weapon rack
|Tools||Bookcase • Hive • Nest box|
|Access||Bars • Bridge • Door • Floodgate • Grate|
Hatch • Road • Window
|Constructions||Floor • Fortification • Ramp • Stairs • Wall|
|Machine and trap parts||Axle • Gear assembly • Lever • Millstone|
Pressure plate • Roller • Screw pump
Support • Trap • Water wheel • Windmill
|Other buildings||Archery target • Kennel • 40d:Shop • Siege engine|
Trade depot • Wagon • Well
|Related articles||Design strategies • Bedroom design • Furniture industry|